The Altistart 48(ATS48) series of soft starters by Square D and Schneider Electric allows for consistent start/stop rates that are independent of motor loads. These devices are more advanced than the standard drives that cannot control the applied motor torque. Featuring contact wiring and control, the soft starter allows for near-seamless integration with existing operations. Many preset parameters are included with the device and they cover a large spectrum of operations. Additional parameters may also be loaded up to meet specific needs. Available power ratings include:
The ATS48 series features a dual configuration of two motors which allows for a cascaded start/stop in many operations. Using the Torque Control System(TCS) the unit can minimize wear on gears which allows for less time servicing the unit.
The Altistart 48 series takes advantage of the PowerSuite™ software for programming of your drive or soft starter. With this software, you will be able to monitor and document all of your operations. Configurations are easily saved via hard disk, CD-ROM, flash memory, etc. Using Ethernet technology, the user is able to configure and monitor operations on the go, and a constant feed of information allows for real-time opportunity to modify and adjust configuration files on the fly.
Troubleshooting can be an issue for people when so many different things are going on. It just isn’t feasible to stop operations every time an error occurs. Below is a list of fault codes for the ATS48 Soft Start series that will help determine most issues:
| Fault Code | Description |
|---|---|
| nLP rdY | Soft start without run command and: • Line power not supplied • Line power supplied |
| tbS | Starting time delay not elapsed |
| HEA | Motor preheating in progress |
| (Use SUP menu to set up monitoring parameter. Factory setting: Motor Current.) | Soft start with run command |
| brL | Soft start braking |
| Stb | Waiting for a command (RUN or STOP) in cascade mode |
| CFF | Invalid configuration on power-up |
| CFI | Invalid configuration |
| CLF | Loss of Control Power |
| EEF | Internal memory fault |
| EtF | External fault |
| ErF | Line frequency out of tolerance |
| InF | Internal fault |
| LrF | Locked rotor fault |
| OCF | Overcurrent fault |
| OHF | Soft start overheating fault |
| OLC | Current overload fault |
| OLF | Motor overload/ground fault |
| OtF | Motor thermal fault detected by PTC probes |
| PHF | Loss of line or motor phase |
| PIF | Phase reversal fault |
| SLF | Serial link fault |
| StF | Excessive starting time |
| ULF | Motor underload fault |
| USF | Lack of AC line power on a run command |
MRO Electric and Supply carries all models of this unit and has a fast and easy repair service to get your unit fixed and back into your hands as soon as possible.
MRO Electric provides the insights and assistance you need to troubleshoot efficiently. Our inventory is stocked with the necessary parts, and our experts are on standby to help you minimize downtime.
End of Year Maintenance As the year comes to a close, it’s the perfect time…
Allen-Bradley Programmable Logic Controllers (or PLC) remain widely used in industrial automation. Programming their PLCs…
The game is almost over, and your team is losing. You can feel the crowd’s…
Whether you’re loyal to the classic, double stuf, or thin OREOs, the addicting cookies always…
Arc flash incidents are among the most dangerous hazards in the electrical industry, posing serious…
Understanding an Arc Flash An arc flash stand as one of the most dangerous electrical…